Hi, Bert Remington.
Specific answers:
1. Odo last reading estimated (bike in shop now): 14,600
2. Battery 2018: Powersports Lithium Ion MMG-6 – Quad terminals
3. No electrical mods. Floorboards, short reach handlebars / risers, bump skid, WOLO horn, Baker air wings, cat delete pipe, teardrop handlebar mirrors, OEM windshield extension. The horn was put on in 2021.
When riding in (typically) higher gears (like 4-5-6), rpms around 3600-4300, I first get the banner Transmission fault and know what to expect after that...better pull off the road safely before no speed at all. I don't put on the brakes as I need to roll the bike somewhere safe as I cannot shift manually or via brake, and have no power...machine will shake as it dies, and I am done. Display shows last gear bike was in prior to the stall, with the exclamation point!
To clear this, I simply act as if it never happened and turn the bike off, then restart the bike. Sometimes I had to do this more than once to clear the display, last time I did it 2X and bike started again. Because I was on a hill this last time, it also would not shift from neutral until it rolled to flat ground. I personally believe it to be a gear sensor or a bad module. All the codes thrown me in 2022 depicted a loss of communication between 3 modules among other codes.
Specific answers:
1. Odo last reading estimated (bike in shop now): 14,600
2. Battery 2018: Powersports Lithium Ion MMG-6 – Quad terminals
3. No electrical mods. Floorboards, short reach handlebars / risers, bump skid, WOLO horn, Baker air wings, cat delete pipe, teardrop handlebar mirrors, OEM windshield extension. The horn was put on in 2021.
When riding in (typically) higher gears (like 4-5-6), rpms around 3600-4300, I first get the banner Transmission fault and know what to expect after that...better pull off the road safely before no speed at all. I don't put on the brakes as I need to roll the bike somewhere safe as I cannot shift manually or via brake, and have no power...machine will shake as it dies, and I am done. Display shows last gear bike was in prior to the stall, with the exclamation point!
To clear this, I simply act as if it never happened and turn the bike off, then restart the bike. Sometimes I had to do this more than once to clear the display, last time I did it 2X and bike started again. Because I was on a hill this last time, it also would not shift from neutral until it rolled to flat ground. I personally believe it to be a gear sensor or a bad module. All the codes thrown me in 2022 depicted a loss of communication between 3 modules among other codes.
Last edited:
