What U-Fit did you choose..

[No 2817]

I got the 2016 F3-T with position 5 and Floor Boards. I was happy with position of the Handle Bars, so I went with stock. I am 6'1" with 34" inseam. I like the furthest position because I can hang my heels off the back of floor board, but still go full forward if I want.

Chris

 

[Bob Denman]

I'm on an RT... but I spent over an hour playing with the test-fit jugs that were on an F-3 at my dealership.
After trying every likely combination: I settled-in at the middle positions for both the pegs and the bars.
The Missus needed everything brought to the shortest possible setup for her.
BTW: I'm 5'10" with a 31" inseam, and she's 5'1" with a 25" set of legs...

 

[HIspyder]

I got the 2016 F3-T with position 5 and Floor Boards. I was happy with position of the Handle Bars, so I went with stock. I am 6'1" with 34" inseam. I like the furthest position because I can hang my heels off the back of floor board, but still go full forward if I want.

Chris

Position 6. 6'4" with 36" inseam. I drilled another hole in the lower frames and lengthened the brake rod. I installed the attitude bars, which are perfect for me since I was leaning too far back with the stock bars.

 

[PrairieSpyder]

I've got the short-reach bars, but they're not quite close enough, at that. My footboards are in position 3, but I'm considering going to 2. I'll decide after this ryding season is over. I'm 5'3" and 29" inseam.

 

[Copperman]

I have position 4 on my floorboards and the middle position on the handlebars.

 

[900Dave]

Stock position on the bars and #4 on the foot boards I an 5' 11" and I feel like I would also be just as comfortable at the #5 position.

 

[Badco149]

I have mine in the #4 Position and am 5' 10" Bars are in the middle and stock.
Work Perfect for me but have not been on a long ride yet.

 

[Ron2andia]

Stock position here 6'0... 36" inseam... Regular handle bars 2