Upright/Knuckle measurements

[paulyboy]

Hello all, I am researching parts for a project. I cannot find any information on the upright/knuckles used in the Spyder. Can any-one direct me to figures for KPI and trail, wheel flange position and ball joint measurements of the upright? Ideally, I would like a drawing showing angles and measurements of the steering knuckle dimensions. I can then CAD the part and check for suitability.

Regards and thanks in advance
Paul

 

[4 MARIE]

let me put you in touch with the INDUSTRIAL ESPIONAGE DEPT.

 

[Chupaca]

R & R....

This is the kind of thing you need to order the part or pull it off your steering to get the measurements...:lecturef_smilie: that data is not readily available to us ....most independents wanting to modify oem parts just get them aND go from there....

 

[paulyboy]

Lol, can I give them a camera and set of calipers?

let me put you in touch with the INDUSTRIAL ESPIONAGE DEPT.

Lol, can I give them a camera and set of calipers?

 

[paulyboy]

This is the kind of thing you need to order the part or pull it off your steering to get the measurements...:lecturef_smilie: that data is not readily available to us ....most independents wanting to modify oem parts just get them aND go from there....

Yeah I agree, but I did not want to go through the cost of purchase only to find out they are not suitable. Just some basic measurements are all that is needed at this point. Thanks for your reply.