What did you do to/with your Spyder today?

[Snoking1127]

This morning I addressed an issue that I had been ignoring. The original owner installed a belt roller, and it was not aligned correctly on the belt. So I just removed it. Maybe someone knows who the supplier was for this? I may want to get a new roller and reinstall it aligned correctly. The Arm is plastic/fiberglass?

 

[CloverHillCrawler]

I installed the replacement Left hand Multi-switch and tested good, Filter from Ron came in yesterday so I changed the oil to get the oil that was in there out.

I ran it pretty hard in 1st gear when the switch was not shifting, it kept getting hot and I would have to stop and idle to let the fans cool it back down before I could keep going.

It only had 3k on it but I changed it out since it was hot.

Tomorrow, I will start cleaning and waxing the panels as I put them back on.

I find it easier to get the scratches out and wax them while the panels are off, plus you don't have to go around with a spudger wrapped in microfiber cloth to get the wax out from in between the panels.

 

[Dakotaz]

This morning I addressed an issue that I had been ignoring. The original owner installed a belt roller, and it was not aligned correctly on the belt. So I just removed it. Maybe someone knows who the supplier was for this? I may want to get a new roller and reinstall it aligned correctly. The Arm is plastic/fiberglass?

View attachment 257559

That is how the one on my wife's 2021 RT looked. Pulled it off and there was a BRP part number that is no longer in use. Says on hers made in Canada. The part number for hers was on the top of the arm non roller side and by the joint where the bolt goes through connecting the metal and plastic arm. Small print.