That doesn't mean it's
NOT the battery, it just means it's a little
LESS LIKELY to be the battery itself, but it also means it's possibly
even MORE likely to be the terminals &/or earth/ground connections! And that's
ESPECIALLY the case if the battery was the last thing you touched before these problems started - often, problems like this are related to the last thing you touched/worked on before they started! :lecturef_smilie:
For example, up until just recently, I'd had absolutely no issues with my Spyder's DPS (Dynamic Power Steering) - at least not
until I replaced the battery! Then within a few days of replacing my Spyder battery with a stronger & brand new replacement that was checked & charged before installation, my Spyder developed some puzzlingly intermittent but savage Power steering surges & faults - only in my particular case it wasn't the battery itself; it was simply a poor connection onto the frame on one of the earth/ground leads some distance away from the battery. Obviously, something I'd done in removing the old/fitting the new battery had moved that cable just enough to loosen the bolt holding the cable terminal onto the frame, and it became loose enough that it caused poor connection problems whenever the cable jolted or moved around as I rode along.... :banghead: And there have been quite a few similar incidents reported here, where fitting a brand new battery has created intermittent or even 'absolutely dead battery' type problems because either the new battery itself failed the very first time it was subjected to any real load, or fitting the new battery ended up with loose terminal connections or made a connection elsewhere just a bit too loose! So even if it
is brand new, you really should still check your battery and all the earth/ground connections you can find!! nojoke
Have you actually tested the battery since this problem came up?? :dontknow: If you can get it checked by an auto elec, then so much the better - if not, you can still do a fairly basic check yoursef just to confirm it's OK.

Get a multi-meter onto it
BEFORE you try to start the engine, and get a voltage reading. Then keep the multi-meter on it
WHILE you try to start the Spyder, watching to see how low the voltage goes; and also to see how high the voltage goes
ONCE the engine starts running. It should read high 12 volts before; not drop much below 12 volts while; and get up to high 13's or low 14's once the engine starts running at revs above idle. Any lower than those, you've got a battery &/or charging problem!! Can you get back to us with what each of those 3 voltage readings are?? :dontknow:
Regardless, if they show the battery/charging system really
IS good, then you don't really have much choice left - it's probably time to get it to a reputable & competent Spyder Technician. :thumbup: