DOCS ROLLER SHORTCUT

[irvin48]

had this posted in the wrong section. if you are installing or servicing your
R.R. vibration damper, you can gain access by only taking off the lower panel behind
the wheel and the side panel. just be careful and get the retainers on the side panel
into the lower finish panel. works for me. maybe you guys have already tried it.
thank you!! --irv

 

[Roadster Renovations]

The is an awesome shortcut. Will save time on the annual inspection/greasing! Good job!

Been thinking about resurrecting a roller we retired at 40k. Bearings were fine. We pulled it because the nylon was showing some wear. I have now created a jig in my lathe that I can take off .001 of an inch at a time across the entire roller without removing the bearings. Put it on the Daytona and run it until if/when it fails. Or me or the byke gets tired of ryding......:roflblack::roflblack::roflblack: (yeah, probably not)