all codes

[DragonLorD]

Hi Guys,
2009, RS, SE5
Installed Power Commander V and Autotune
Cut off factory O2 sensor since Autotune has its own and therefore didn't see a point to plug in PCV O2 modifier inline with factory O2 , firstly - it just make a sense and secondly - i've seen guys from here done just the same
Autotune connected directly to Battery.
Had bike started and let reach 3 bars temperature twice before i pulled it out from garage, got ready for a ride and:

- bike won't start, not even click, just keep coming back to safety message after each attempt
- these codes are scrolling across the screen: check engine, check DPS, VSS failure, Break failure, ABS failure - :gaah:

So i disconnected battery for half an hour, unplug and back plug all 4 rellays, checked fuses at front and back - all good, checked break fluid - perfect, checked seat sensor connection, reconnected battery - same all.
Lights are all on and working, gear is in N, killer switch is off,
Charged Battery over night - no joy

Anyone up for help?
btw - air-conditioning and seat belts are fine

 

[NancysToy]

First, the OEM sensor still has to remain in place with the additional sensor for autotune installed in a separate, welded-in bung, from what I understand. Second, we are going to need more than the warnings on the screen to pin things down. Display the active faults and get back to us.

 

[DragonLorD]

...

First, the OEM sensor still has to remain in place with the additional sensor for autotune installed in a separate, welded-in bung, from what I understand. Second, we are going to need more than the warnings on the screen to pin things down. Display the active faults and get back to us.

1,- right, that is easy fix although won't happen this week, just too busy

2,- i was never able to display active faults ever no matter what i did - 3 x key and mode button and who knows - i always got it wrong but sure you live and learn , i blame teachers in this case :yikes:

 

[NancysToy]

1,- right, that is easy fix although won't happen this week, just too busy

2,- i was never able to display active faults ever no matter what i did - 3 x key and mode button and who knows - i always got it wrong but sure you live and learn , i blame teachers in this case :yikes:

To display fault codes on 2008-2012 GS/RS...

Turn key on (or keep key on)
Scroll to display total engine hours
Press and hold MODE button while pushing "Flash High Beams" rapidly 5 times within 2 seconds
Display will scroll active fault codes or read "No Actve Fault Codes"
If codes or message are not displayed, repeat procedure. Usual reason is failure to complete 5 flashes of high beams within 2 seconds.

You can pactice this procedure without any active faults, just to hone your technique.