DesertCraw4th
New member
Hello everyone -
Before I get my 2021 RTL towed to the shop I thought I would check for anything I've missed or haven't tried. The Brake Failure light is on and the Spyder will not start. I can't get past the start screen to check fault codes (mode key does not clear the "read safety card screen"). I had just ridden the RTL two days before and now stuck without being able to start.
Here is the list of items tried and result:
1. Battery checked and charged - no change
2. Tried the brake pedal reset (hold down brake HARD, turn off key, hold brake for 30 seconds) multiple times - no change
3. Opened brake fluid reservoir, checked levels, seemed good and added some brake fluid anyway - no change
4, While the brake fluid reservoir was open checked both floats - both move freely and are at top of range - no change
5. Used ohm meter to test both brake fluid level sensors while still in the reservoir - both at 4.5K ohms - no change
6. Checked all fuses - none blown
Is there any other way to reset the Brake Failure?
Thanks in advance!
Before I get my 2021 RTL towed to the shop I thought I would check for anything I've missed or haven't tried. The Brake Failure light is on and the Spyder will not start. I can't get past the start screen to check fault codes (mode key does not clear the "read safety card screen"). I had just ridden the RTL two days before and now stuck without being able to start.
Here is the list of items tried and result:
1. Battery checked and charged - no change
2. Tried the brake pedal reset (hold down brake HARD, turn off key, hold brake for 30 seconds) multiple times - no change
3. Opened brake fluid reservoir, checked levels, seemed good and added some brake fluid anyway - no change
4, While the brake fluid reservoir was open checked both floats - both move freely and are at top of range - no change
5. Used ohm meter to test both brake fluid level sensors while still in the reservoir - both at 4.5K ohms - no change
6. Checked all fuses - none blown
Is there any other way to reset the Brake Failure?
Thanks in advance!