I am having a hard time just getting to the screen and when I do it doesn't work. I thing I am doing what the book says but missing something. I am beginning to believe it's time for a visit to the dealer. :banghead:The instructions in the manual seem simple enough. Where are you getting stuck?
DisplaySettings
SettingMetric/Imperial Units
1. Push and hold SET button on the
RECC for three seconds.
2. Push _down arrow_ to select KM,
push up arrow to select MI.
I think that you need to tap the "Mode" button, until you get to the Preferences Screen...
When you get to it; you should see a whole bunch of options that you can tinker with...
I THINK that miles and kilometers are over in the right hand side... use the "right" arrow button to get over to them...
Once you're there; just use the up or down button to pick which one you want.
Tap "MOde" again; to exit and save your settings...
I'm not sure...
He's got an F-3; are they the same as for the RS? the ST? The RT? or something completely different? :dontknow:
(I was guessing with the RT instructions, and should have mentioned that!pps
![]()
Did it like this and you would think I knew what I was doing!:shocked: Thanks everything is good now! Let's ride.:clap:The printed instructions are not very clear.
This is the quick guide original, If you follow it as a step by step, you will always get Km:
![]()
A quick and dirty Photoshop shows how it should read:
![]()
If you have the mileage display selected on the Speedo, you will see it change.
Did it like this and you would think I knew what I was doing!:shocked: Thanks everything is good now! Let's ride.:clap:
Did it like this and you would think I knew what I was doing!:shocked: Thanks everything is good now! Let's ride.:clap:
You are genius. The internet is full of people having trouble changing from KMH to MPH. The MANUALS are all wrong!!!
This is how to do it and it works.
Good job CanAmChris