tuperware fittings rts

[nasty]

Hi all,
Have noticed that one of the pegs (plastic pins ) that hold the middle panel on is split,the one that is slightly bent, have managed to remove this and will glue the split, can a new replacement be bought.
If S Can anyone out there give me a part number?.
Going to see if the lathe turning at work can make a replacement in stainless.
cheers .

 

[Easy Rider]

See your local dealer.

Highly unlikely that stainless will work, as those pins are designed to expand and contract as they are being pushed IN or OUT.

Any dealer that does much Spyder work at all should have them on hand all the time.

 

[Cruzr Joe]

Hi all,
Have noticed that one of the pegs (plastic pins ) that hold the middle panel on is split,the one that is slightly bent, have managed to remove this and will glue the split, can a new replacement be bought.
If S Can anyone out there give me a part number?.
Going to see if the lathe turning at work can make a replacement in stainless.
cheers .

www.spyderlovers.com they are called push pins and you can buy them on this site.

real cheap

Cruzr Joe

 

[pegasus1300]

actually if you take one down to your local NAPA store they have them there.

 

[Cruzr Joe]

Do they have NAPA stores in England???

Cruzr Joe

 

[SpyderAnn01]

Is he talking about a push pin or the prong that goes into the rubber grommet?

 

[Purple Guy]

Is he talking about a push pin or the prong that goes into the rubber grommet?

I believe he is asking about the "non removable" prong...
Not sure that can even be replaced, couldn't find anything on the parts diagram...

 

[SpyderAnn01]

The tamper resistant ones can be replaced. We have done it, I think we bought them from the dealer, so they should be available elsewhere.

 

[Easy Rider]

I believe he is asking about the "non removable" prong...
Not sure that can even be replaced, couldn't find anything on the parts diagram...

Oops. Those are molded as part of larger plastic panels and would not be available by themselves.
Sorry that I helped the discussion take a wrong turn.

 

[ris]

I purchased mine thru. Cheapcycleparts.com. they are about $5 each

 

[BLUEKNIGHT911]

Hi all,
Have noticed that one of the pegs (plastic pins ) that hold the middle panel on is split,the one that is slightly bent, have managed to remove this and will glue the split, can a new replacement be bought.
If S Can anyone out there give me a part number?.
Going to see if the lathe turning at work can make a replacement in stainless.
cheers .

I went a different route ...I Hated those fittings, so I removed mine, and switched to Screws ….. First I pop riveted some thick soft plastic disks where the Grommets were , then I removed the plastic things , then I put the panel back on and held it there and drilled small holes into the NEW plastic disks …. Yes I have to use a screw driver to open the Panel, and a have a small power one that works great. …...…… I did something similar to lower front panels that POP off …… never gonna loose one now ..:clap:..... Mike hyea:

 

[Purple Guy]

The tamper resistant ones can be replaced. We have done it, I think we bought them from the dealer, so they should be available elsewhere.

Good to know, Thanks Ann!