I now have everything except the hydraulic hose line. I know that it has to have a banjo fitting on the master cylinder end. Probably a 10mm to fit the one I have. What do I order for the slave end. I have the same red one that was ordered on ebay. What is the fitting called size etc that I should order on the line? If I could find a custom shop that would put a banjo on one end and reduce to a 3/16 tubing on the other end, I could just use the 90 degree fitting I have and I would put a double flare on the end of the tube after sliding my fitting over the tube. Any information on what or where I can order would be greatly appreciated.