Where can I get Switched Power for Frunk LED Strip on '20 F3-T?

[jfl330]

I bought Lamonster's Bright Ryder frunk led strip. I watched his video but thats an older F3, wiring in same area very different in my wife's 20 F3T.

I have service manual but cannot determine where I can get a switched power to connect led strip to.

Any insight greatly appreciated!

 

[wolfeman]

F3Ts must be different than the F3S. I have a '20 and Lamonster's video instructions were spot on.

 

[jfl330]

It's not, just couldn't find the darn accessory lead stuck in the corner of the frunk!

 

[RickWB]

I recently installed LaMonster's light strip on my 2019 F3 base model. I remove the frunk liner, found the accessory power supply and connected to that. It was pretty much identical to LaMonster's video.

 

[BanditoRS]

When I hooked up my LED frunk light strip the accessory lead was under the rear of the frunk liner as the others have said. I think mine was tucked down in so make sure you look real close because you may not be able to see the end if tucked down behind other wires. I believe I watched Lamonster's vid also. Good luck.