What lift are you using to lift your 2023 RT?

[Metalman]

I just read about using the Big Blue lift to lift the Spyder. The lift is expensive, it would take up too much room in my garage, and the lifting process seems extremely complicated. I have used a Craftsman aluminum motorcycle/ATV lift, but it's kind of scary (not particularly stable). Once lifted, I set the three wheels on nine inch tall blocks and remove the lift.

I am curious what others are using for lifting their trike.

 

[Lew L]

I just read about using the Big Blue lift to lift the Spyder. The lift is expensive, it would take up too much room in my garage, and the lifting process seems extremely complicated. I have used a Craftsman aluminum motorcycle/ATV lift, but it's kind of scary (not particularly stable). Once lifted, I set the three wheels on nine inch tall blocks and remove the lift.

I am curious what others are using for lifting their trike.

Just about the same. I use jack stands in the front and a large block of wood in the back. Been doing it this way for a decade...

 

[hogmemberisold]

Everything I've went to, to accomplish lifting the Spyder, and could start over would be a low profile high lift jack, jack stands, ramps, and lifting pads.

 

[Mikey]

Try a search at the top of the page this subject has been hashed over a lot! Good luck!

 

[UtahPete]

Is there something unique about a 2023 RT that demands special equipment or technique for lifting? Because there are many, many threads already on the forum about lifting a Spyder. I recommend you do a little searching and reading at this point. Good luck.

 

[Metalman]

I have no idea if the RTL is different than other models as far as lifting. I have looked at several posts about lifting and lifts, but I would like more up-to-date information. I have lifted the Spyder a few times and I'm not really confident in the Craftsman aluminum motorcycle/ATV lift and was wondering if there are better lifts available and what they are. I don't have room for a lift table and I'd like to be able to get the bike higher than its road clearance height above the floor/table for oil changes. I would also like to have a stable lift that raises the bike more than my Craftsman lift.

 

[UtahPete]

Well, most of these threads involve recent info about lifting the RT. See if that helps. Also, in the years I've been on this forum, there have been no new developments in lifts or techniques for getting the Spyder safely off the ground to work on. Keep that in mind.

Search results for query: motorcycle lift