what do you use to lift for oil change

[kbwitt]

Any one have the race car rr40 ? Can you drive right up?
TIA Kenn

 

[Chupaca]

Really. ...

You don't have to lift the spyder at all for changeing oil. I have ways but in the end on the ground has worked the best for me. Old bones, crapy knees, bad back and bumb leg and all :dontknow:

 

[vided]

I perfer to use the dealer :roflblack::roflblack::roflblack:

 

[Mazo EMS2]

I've used regular car ramps in the past, but really, it doesn't need to be lifted at all.

 

[Pampurrs]

I use a Harbor Freight ATV/Motorcycle lift to get it in the air, then set it down on jackstands. Yes, as others have said, you can change the oil without lifting it, but I prefer to have some room to work.

Pam

 

[hdspyder]

I use three boards 2x8x1' one end cut on a 45 angle. Drive on them, gives room for drain pan.

 

[jcthorne]

I use our shop lift...

 

[Buckeye Bleau]

I use our shop lift...

View attachment 133140

Now that is just cheating! So wrong to post that for us less fortunate folks!

 

[Bob Denman]

I prefer to use the dealer :roflblack::roflblack::roflblack:

I think that you must have copied MY plan! :roflblack:

 

[AY4B]

I use a Harbor Freight ATV/Motorcycle lift to get it in the air, then set it down on jackstands. Yes, as others have said, you can change the oil without lifting it, but I prefer to have some room to work.

Pam

Thats what I do, whats so hard about that? Jackstands in the front, floor jack under the rear tire, pull out the ATV jack and you have all the center open to work.