I have a Can Am Spyder RT SE6 2015. I was on Cheapcycle parts and looking at the drive system rear. It shows the 2015 has the rear wheel with the hub that bolts to the wheel. I ordered bearing and seals just to have on hand from this. When I changed my rear tire yesterday my wheel is one piece other than the belt drive pulley. There was no hub to unbolt. I just went on the parts break down again and looked at the Spyder RT SE6 2016 and it has the one piece wheel like mind. Has anyone had this on their 2015. I am glad I ordered the bearings and seals I think they are the same. I did need to replace the o ring on the belt drive pulley