re install ecu

[ssmcclub]

when installing the ecu after having it flash do you have to push in the release taps when you install the ecu?

 

[AY4B]

No Just push the plugs in securely and push the latch lever over to the locked position. The small tabs on the side should just lock in place then put the screws back in. Ite easier to re install the it was to remove it. Let us know how it goes and how you like the flash. Did you get stage one or two?

 

[ssmcclub]

ok thank you ay4b, went for the stage one will let you know

 

[AY4B]

That is what I got and am loving it.

 

[308gunner]

ok thank you ay4b, went for the stage one will let you know

You`re going to love it.

 

[Dennis in Lodi]

correct side out

when installing the ecu after having it flash do you have to push in the release taps when you install the ecu?

Before you mount the ECU make sure the correct side is out. Test a plug and confirm it will start into the ECU socket. The ECU mounts both ways and looks more correct the wrong side out.
Harness only fits when installed the correct side out.
Dennis
Note that when your ECU is installed it will initially feel the same. The Spyder sensor inputs will start to give input data that the ECU will respond to to make mapping, timing and torque changes. I Have tested about 25 flashes for monster fuel and to me it seems to take about a tank and a half of gas to get the full benefits of the flash.
Enjoy.

 

[Rattlebars]

Before you mount the ECU make sure the correct side is out. Test a plug and confirm it will start into the ECU socket. The ECU mounts both ways and looks more correct the wrong side out.
Harness only fits when installed the correct side out.
Dennis
Note that when your ECU is installed it will initially feel the same. The Spyder sensor inputs will start to give input data that the ECU will respond to to make mapping, timing and torque changes. I Have tested about 25 flashes for monster fuel and to me it seems to take about a tank and a half of gas to get the full benefits of the flash.
Enjoy.

I would suggest marking the "outside" with a dab of paint and taking a photo of it before you remove it. When I do something like that, I always take several photos of the process. Digital photos are free these days and my memory is not what it used to be.

 

[AY4B]

I also took a piece of painters tape and put my name on it. I do not know their process and wanted to make sure I got the same one back. Take it off when you re install.

 

[AY4B]

You will be charged the return shipping when you order the flash.