The doubled ended tool for removing my panel screws isn't working. The larger end is fine but the smaller end will not fit the smaller screws. What toolbit and size do I need to remove them? I'm trying to route a power cable for my GPS and ran into this problem. Thanks in advance.:dontknow:
-
There were many reasons for the change of the site software, the biggest was security. The age of the old software also meant no server updates for certain programs. There are many benefits to the new software, one of the biggest is the mobile functionality. Ill fix up some stuff in the coming days, we'll also try to get some of the old addons back or the data imported back into the site like the garage. To create a thread or to reply with a post is basically the same as it was in the prior software. The default style of the site is light colored, but i temporarily added a darker colored style, to change you can find a link at the bottom of the site.
Pulling panels?
- Thread starter skypup
- Start date
ThreeWheels
Active member
Are you talking about the two small screws on the bottom of the side panel in front of the seat ?
If you are don't make the same lame mistake I did. Those screws are connected to studs that are mounted in the rubber grommets. You don't have to remove the screws, just gently pull that part of the panel off after removing the other screws.
If you are don't make the same lame mistake I did. Those screws are connected to studs that are mounted in the rubber grommets. You don't have to remove the screws, just gently pull that part of the panel off after removing the other screws.
Thanks! Now I don't feel so bad:thumbup:
We did the same thing. Called the dealer and the service techs there said they did it too! Funny thing is, the manual says they are screws!:yikes:
Similar threads
