New Key Holder

[Mike Ard]

Here is a picture of the key holder I found on line that does not involve drilling a hole in the key. I ordered 2 so the silver one is on the key and the black one is not. They are a bit spendy but are very well made.

 

[Tango]

Bought 2 of those also. :thumbup: Tom :spyder:

 

[Jamesmozz]

Have the same. Really good. eBay job for the UK [emoji106]

 

[Bob Denman]

They are a nice-looking piece! :clap:
But I went for the cheaper alternative, and drilled the keys.
The chips are encased in plastic, so no harm can befall them! :thumbup:
(Unless you put a drill bit through them! :yikes

 

[oldguyinTX]

Very nice. Where did you get them? Can you post a link?

 

[Mike Ard]

They are a nice-looking piece! :clap:
But I went for the cheaper alternative, and drilled the keys.
The chips are encased in plastic, so no harm can befall them! :thumbup:
(Unless you put a drill bit through them! :yikes

Would have loved to drill the key but.......knowing myself I can guarantee with out a doubt or any reservation..................well you know

 

[Mike Ard]

Very nice. Where did you get them? Can you post a link?

Did a search on Ebay for Spyder accessories. They say not for the F3 or any of the 15's but I compared the key on my F3 with an 08 GS, and a 2011 RT and there is no difference in the keys so will work on any Spyder

 

[Madrebel]

Very nice. Where did you get them? Can you post a link?

Amazon has them with much quicker delivery. A few days instead of weeks.

 

[Bob Denman]

Would have loved to drill the key but.......knowing myself I can guarantee with out a doubt or any reservation..................well you know

I sure do understand your reluctance... :shocked:
If it can be done wrong; I've managed to do it! pps:

Here's a picture of a key that has been drilled in the proper spot! :thumbup:

 

[jerpinoy]

I sure do understand your reluctance... :shocked:
If it can be done wrong; I've managed to do it! pps:

Here's a picture of a key that has been drilled in the proper spot! :thumbup:

What size of drill bit did you used?

 

[Bob Denman]

JUST about big enough to allow the keyring through...
It might even have only been a 1/8" bit...
If you take the bit in your hand; you can actually poke it right through the key when you hit the right spot. :shocked:
The hole is already there! nojoke

 

[bmwlarry]

I have one of those key holders. I would be reluctant to drill even if you can avoid electronics. That would be an excellent place to let water to sneak in and cause may Electrical problems.

 

[Bob Denman]

The chip is completely encased in plastic...
I wouldn't have DARED try it; if I hadn't seen how the chips are sealed-up. :thumbup:

 

[mcpjan]

I have gotten 4 of them 2 for each bike. They work great and a little loctite they will not come off...