need help screw size?

[almosthere]

I am putting the primary muffler back on my 2015 RT-S SE6 and am missing the 3 small screws that hold the plate with the 2 front rubber hangers. Can anyone tell me the size that I might be able to pick them up at the hardware store? Or are they a speciality item only obtained at the dealer, if so what the part # might be?

 

[DGoebel]

From Cheapcycle parts, under the 2015 RTS SE6, Exhaust parts breakdown,
https://www.cheapcycleparts.com/oemparts/a/cam/546f7a62f870022084623daf/exhaust-system
Hex. Forming Screw M6 X 20 Part # 210262050

 

[almosthere]

thank you much
So if I get 6mm x 20 at hardware store they should work?

 

[DGoebel]

Yes they should, I don't think there's any variation on thread pitch with Metric bolts at that size.

 

[almosthere]

Thank you again will get those in the morning.

 

[almosthere]

Ok got the screws and was tight but got the front hanger plate re attached. primary muffler, (cat.), slid into front hanger rubbers fine. NOW how do you get the top rubber hanger to slide on to both hooks? I can slide it on to one or the other but can't seem to stretch it to go over both. Then it looks like the inside spring is going to be almost impossible to stretch to attach.
HELP Please!