Need a low profile lift table recommendation

[1Vetteman]

The lift table I used to park my Freewheeler on is too tall (6 inches) when completely lowered for the Spyder to get completely on. It gets hung up about two thirds of the way on.

I watched a youtube video where the table was about 2 inches tall when lowered and had 2 short side plates the Spyders front wheels rested on.

Thanks in advance for any recommendations on such a lift table.

 

[Mikey]

Build yourself some longer ramps, or make a center ramp that lifts the rear, so it doesn't hit in the transition point!

 

[EdMat]

From the description a 2 x 12 x2' might be all you need to add

 

[1Vetteman]

Thanks for the suggestions. I think I'll sell my existing lift table. It needs to be in the 60 + inches wide range to accommodate the front tires, it’s 48” wide with the side extensions. I found one from a company in Iowa that is 36” center width with two 15” X 45” side extensions for the front wheels.

I would really like to find the one with the aluminum diamond plate top shown in a youtube video. It appears to be about 2 or 2-1/2 inches tall when fully collapsed.

 

[Ozarkwoods]

You could always sink your lift so it is flush with the floor surface.