Limp Mode

[Roy's Bassets]

Yesterday got a limp home code, faults were, abs vss dps. Stopped and shut down. Pulled the breakers fuses, made sure all were OK. Started back up and faults were still on, started riding and faults went away. Rode about 50 miles bam :gaah:limp mode again. Was not far from home so drove on home. Checked the codes, codes were c0034, p2545, and u0122. Faults were still on after :spyder2: set for a while, again rode a round the block fauths went away. Any one know whats up here.

 

[the nicko]

c0034 is wheel speed sensor check wheel sensor and damage tooth wheel

p2545 vvs faliure

u0122 dps comunication faliur

 

[NancysToy]

Sounds like a wheel sensor either got blocked temporarily, came loose or out of adjustment, or the wire came loose. The wheel sensor issue was probably primary, but that can trigger the VSS and DPS failure messages, as those systems depend on the wheel sensor information.

 

[Latemarch]

Sounds like a wheel sensor either got blocked temporarily, came loose or out of adjustment, or the wire came loose. The wheel sensor issue was probably primary, but that can trigger the VSS and DPS failure messages, as those systems depend on the wheel sensor information.

:agree: and there's a sensor gauge for adjusting in the Spyders tool roll.

 

[lightman02]

Could be faulty relay or battery issues such as loose or corroded connectors.

 

[Roy's Bassets]

limp

:agree:I hooked up the battery tender, charged over night, rode about 40 mi today no problem. maybe it was just the battery. hopefully:bowdown: