hesitation

[bmccaffrey]

I've got a 2013 rs. I've noticed a couple of times going around a corner and rolling on the throttle I get a hesitation. No nanny or codes. If I let off it comes back.
Ideas:bowdown:

 

[sabunim5]

Nanny is my guess

The Nanny is probably just curbing your throttle hand by retarding the ignition until she decides it's "safe" to give it that much gas.

 

[Marker]

Vacuum Hoses ??

could be the small black 3.5"long vacuum hoses that are located in the front of the engine.
I had to replace them on my 2010Rt . The engine would run rough and stall with no codes showing.
When I checked the hoses they were both dry and cracked the inner one closer to the exhaust manifold was the worst.
New hoses the spyder runs great and has lots more throttle response.

I had about 25,000Km on it when I changed the hoses.

 

[bmccaffrey]

Possible with a hose but being a year old with 5000 mi :dontknow:
No rough idle. Good response on straightaway:thumbup:

 

[Magdave]

I've got a 2013 rs. I've noticed a couple of times going around a corner and rolling on the throttle I get a hesitation. No nanny or codes. If I let off it comes back.
Ideas:bowdown:

Mine has done this at times. Sometimes when turning right from my road onto the highway I hit it hard and get a touch of it. I have learned to start a hair slower on the throttle till I get it straight. Last time I had a BUDS check there were lateral sensor codes ( a few) that never popped a code on the screen. Nanny at work:dontknow: If you are an aggressive driver in the twisties I think she gets heartburn.

 

[wyliec]

I've got a 2013 rs. I've noticed a couple of times going around a corner and rolling on the throttle I get a hesitation. No nanny or codes. If I let off it comes back.
Ideas:bowdown:

I kept getting the same thing at the same corner when going to work. After about the 4th time I realized there was sand at that corner. I corrected the problem by not going to work.

 

[billybovine]

I've got a 2013 rs. I've noticed a couple of times going around a corner and rolling on the throttle I get a hesitation. No nanny or codes. If I let off it comes back.
Ideas:bowdown:

If it is the VSS kicking in, the VSS light will come on. The problem is that the light could be on for so short a time it will be hard to catch. If you find out it is the VSS and it does not seem reasonable when it is kicking in, have the sensors checked.

 

[billrob71]

Still thinking like has been said VSS system kicking in, that little red light is about impossible to see during the day. As overprotected as nanny is think that's probably all you got going on there

 

[billrob71]

I kept getting the same thing at the same corner when going to work. After about the 4th time I realized there was sand at that corner. I corrected the problem by not going to work.

Nice
I like this theroy can I tell my boss that :roflblack:

 

[bmccaffrey]

Couldn'tTE=wyliec;868287]I kept getting the same thing at the same corner when going to work. After about the 4th time I realized there was sand at that corner. I corrected the problem by not going to work.[/QUOTE]


I like that answer. Think I will give it a try:yes::thumbup:hyea:

Couldn't get it to do it today:dontknow:

 

[MikeinGA]

It maybe that your shock springs are not set correctly. In your Operator Guide on page 48 it shows how to adjust the shock springs under Adjusting Suspension.

Mike