HELP!! - Throttle OEM Heated Grip not working

[aracrash]

I have a 2015 F3-S SE6 that need heated grips. I installed the OEM heated grips. After many hours of taking panels off and installing the grips, I cut it on to test. The left handlebar warmer worked like a champ. (Very Hot). The right did not get warm at all. I retraced my steps and still no success. I checked the fuses and there was no issues there either.

I might have to take the bike to the dealership to get them to look at it.

Anyone have any suggestions?

 

[Centurion]

I am adding the heated grips to my F3 this week as well. I am complete with the left grip wiring but still amidst the throttle grip wiring. Did you check the two connections where the wires plug into the power source? Perhaps the connection for the throttle side wire is not fully seated.

 

[aracrash]

I checked all connections several times and they are fastened tight.

Also, have you installed grips before on a Spyder before? If not, the spring is a bit tricky.

 

[Centurion]

Did you get your grip working. I finished the installation this evening and both of mine are heating up very nicely. Overall, it wasn't that bad, just a lot of discovery learning. Any you are correct that spring is very tricky!

 

[aracrash]

I did not get the grip working but i found out the issue. I tested the right grip by switching the connect with the left one to see if it got hot. It did not but the left one did. So I am returning the grips and getting another pair.