Just how important is it to take a 2019 Spyder RT Limited to a dealer for the first oil change? The dealer I purchased it from says to bring it in for the first service at 3,000 miles. Cost would be around $300.00. I traded in a 2015 Spyder RT with 40,000 miles on it and it had never been back to any dealer. It had about 8,000 miles on it when I purchased it and as far as I know it was never taken to a dealer. I have always done all my own service. I always to all the services at the miles that are recommended. I never liked anyone doing anything to my motorcycles. The only thing I had on my 2015 was I had to change the DESS Module which I did myself. I have purchased around 35 new motorcycles in my life time. I have only had one back to a dealer. That was a 2005 BMW K1200LT. It had to have a rear drive replaced. I have 1500 miles on this 2019 and it could not handle or run any better. I don’t understand why I cannot change the oil in it at 3,000 miles and save $300.00. I will purchase the Can Am oil kit with filter and have the receipt for proof I changed it.
My 2015 I had lasered aligned it myself; replace tires with car tires (I have my own tire changer), installed Bajaron sway bar, and belt tensioner. When I replace the original tires they will be car tires. Right at present time I am not going to but the sway bar on or the belt tensioner. I ride alone and only weight 150 lbs. and I don’t notice the sway bar and I have no vibration. It took a little time getting the belt aligned just like I wanted it. I can just put the thickness of a credit card between the belt and rear pulley flange. Down the road I my put the Bajaron sway bar on if I feel I need it.
My 2015 I had lasered aligned it myself; replace tires with car tires (I have my own tire changer), installed Bajaron sway bar, and belt tensioner. When I replace the original tires they will be car tires. Right at present time I am not going to but the sway bar on or the belt tensioner. I ride alone and only weight 150 lbs. and I don’t notice the sway bar and I have no vibration. It took a little time getting the belt aligned just like I wanted it. I can just put the thickness of a credit card between the belt and rear pulley flange. Down the road I my put the Bajaron sway bar on if I feel I need it.