Fable of the 2020 RT Handlebar

[cptjam]

Use stock bars and Lamont’s riser.

 

[Copperman]

The 2020 and 2021 RT and RT Limited have an identical dash/steering column/etc. If something fits one, it will fit the other. Per jetfixer (who has Attitude bars installed on his 2020 RTL), they fit w/o add'l modifications. I haven't tried it myself because I have a 2018 but I don't doubt him.

I have the F3 "Long Reach" bars on my 2020 RT Limited. I see you're looking to upgrade to a 2020 or 2021 RT. I'll be in Maggie Valley next week for the rally and staying across the street at the Quality Inn. Look me up, or send me a PM, and check them out.

 

[MRH]

I have the F3 "Long Reach" bars on my 2020 RT Limited. I see you're looking to upgrade to a 2020 or 2021 RT. I'll be in Maggie Valley next week for the rally and staying across the street at the Quality Inn. Look me up, or send me a PM, and check them out.

Thanks for the invite, but I won't be ale to make the rally. Have a blast!

 

[ButterSmooth]

First off, thank you for comfirming that the reduced reach bars will also likely be too close for me.

From what I can tell, that part number is for the stock F3 bars. I found this link for the F3 after I made my post that seemed helpful and makes me think that the 709402241 would be best:
https://lam.can-am.brp.com/on-road/spyder-f3-fitment.html

I've spent a few hours riding with the 709402241/F3 bars, and they are the best so far. At 5'5", I'm probably at the short end for them, but they are as good a fit as I've ever had. These probably should be the stock bars on the RT.