F3 just stopped running

[shroth]

My F3L was running fine then got really rough. Then it wouldn't start at all. Off to the dealer......code for bad can position sensor I think....

Is this a known/common issue? Tried to search the forums......didn't find anything......but them I'm a guy, we can't find anything!!

 

[bluewoo]

https://www.spyderlovers.com/forums/showthread.php?79867-Help!!!-Stranded-in-Key-West-with-a-new-2015-Limited-Spyder

https://www.canamspyderforums.com/forums/can-am-spyder-general-discussion/22186-camshaft-position-sensor-failure-2015-rt-limited.html

https://www.spyderlovers.com/forums/search.php?searchid=342333

 

[Gwolf]

my f3l was running fine then got really rough. Then it wouldn't start at all. Off to the dealer......code for bad can position sensor i think....

Is this a known/common issue? Tried to search the forums......didn't find anything......but them i'm a guy, we can't find anything!!

po 340 ?

There is a fuse for that and it could be blown.

 

[shroth]

Would you believe a bad gas cap that allowed water & snow to get in the fuel when I trailed her back from NC to Buffalo. Since it's a factory defective cap we'll see what BRP does.......

 

[bluewoo]

Thanks for the update! Hope it gets corrected quickly!!

 

[shroth]

Forgot to update.....was working on a health issue. So the F3 is back home. BRP covered a new gas cap & fuel filter plus all the labor. I was told this is part of the emissions system.

Running great again & the cap is totally flat to the tupperware.

Loving my dealer & actually can't complain about BRP........ok, a week for a part is a bit long :shocked: