castle lcok nut

[Andy Cserny]

does this castle lock nut listed on eBay fit the bub of the Spyder rear wheel?
http://www.ebay.com/itm/SWINGARM-PI...402f39a&pid=100033&rk=1&rkt=1&sd=200658150133

I dont need one yet, but I am sure I will at some point in time.
thanks
Andy

 

[pitzerwm]

There are a bunch of measurements in the ad, you should be able to verify that it fits.

 

[Doc - Riverside]

Tool

A Park tool FR-6 will work. I just used it when I replaced the bearing on the rear wheel. It could stand to be larger in diameter but the tooth width keeps it centered. Plus it only costs about $14.00.

http://www.nashbar.com/bikes/Produc...0&cadevice=c&gclid=CM7Q3fKL5cQCFY8kgQodphgAjg

 

[Andy Cserny]

castle lock nut remover

A Park tool FR-6 will work. I just used it when I replaced the bearing on the rear wheel. It could stand to be larger in diameter but the tooth width keeps it centered. Plus it only costs about $14.00.

http://www.nashbar.com/bikes/Produc...0&cadevice=c&gclid=CM7Q3fKL5cQCFY8kgQodphgAjg

Thanks Doc, where do you come up with all this valuable info??!! I just ordered one because I know that one of these goodies is pure nonobtainium in my backwoods part of the world.
Andy

 

[finless]

Thanks Doc, where do you come up with all this valuable info??!! I just ordered one because I know that one of these goodies is pure nonobtainium in my backwoods part of the world.
Andy

Because DOC as been there and done that and knows what he is doing

FYI I took this note myself! Thanks DOC!

Bob

 

[SNOOPY]

A Park tool FR-6 will work. I just used it when I replaced the bearing on the rear wheel. It could stand to be larger in diameter but the tooth width keeps it centered. Plus it only costs about $14.00.

http://www.nashbar.com/bikes/Produc...0&cadevice=c&gclid=CM7Q3fKL5cQCFY8kgQodphgAjg

Same one I bought a couple months ago. :thumbup:

.