Car and Motorcycle show for charity

[Phil]

I'm entering Darth and Darth Trailer into the Tyler, Texas' East Texas Crisis Center Car and Motorcycle Show.
http://i1188.photobucket.com/albums/z402/CorporateGreen/My Spyder Mods/c3eae970.jpg

Come by!
Feb 1-3 at Harvey Convention Center
http://autoandcycleshow.com/
Schedule- http://autoandcycleshow.com/schedule.html
Map- http://autoandcycleshow.com/map.html

All for a great cause.

Phil, Tyler TX- from my iPad3.5 using Tapatalk HD

 

[ARtraveler]

That will be a beautiful entry. Let us know how you do. :thumbup:

 

[TicketBait]

Good cause and I am sure you will have a great time Phil, ( a little break from all thats going on at your business), :yes:take a photo of the coolest car there also, if you have time. And bring home a trophy :firstplace:

tb

 

[MarkLawson]

Good luck in the show Brother!

 

[Phil]

Darth is in position along with 100 other cars and bikes.

It's@ Harvey Convention Center at the ET Fairgrounds. Friday 4-9pm. Sat 9am-9pm. Sunday 9am-4pm. Proceeds benefit the East Texas Crisis Center. Win a refurbished classic Mustang! $10 raffle.


Phil, Tyler TX- from my iPad3.5 using Tapatalk HD

 

[NancysToy]

Did'ya get your battery situation worked out with the fire marshall?

 

[Phil]

Did'ya get your battery situation worked out with the fire marshall?

Yup. SUPER easy. Removed the ground ( holding that nut in place and putting the screw back in the terminal to hold the nut in place). Peeled back the two ground wires, put a screw with nut through them, add the neg wire from the 12v supply, tighten. Added a mini clamp connector to the supply + side and attached to the pos post. Turn the key on, fire up all lights and whala!!

I tried the back feed and feeding into the trunk and only some of the lights worked. Then tried a power outlet I added to the from of Darth and a different group came on. So.... I decided to do it the right way and feed the 12v supply right to the same place as the batter would. Great wow factor. Thanks for helping me talk it through Scotty!!

Back to your design work!


Phil, Tyler TX- from my iPad3.5 using Tapatalk HD

 

[NancysToy]

Yup. SUPER easy. Removed the ground ( holding that nut in place and putting the screw back in the terminal to hold the nut in place). Peeled back the two ground wires, put a screw with nut through them, add the neg wire from the 12v supply, tighten. Added a mini clamp connector to the supply + side and attached to the pos post. Turn the key on, fire up all lights and whala!!

I tried the back feed and feeding into the trunk and only some of the lights worked. Then tried a power outlet I added to the from of Darth and a different group came on. So.... I decided to do it the right way and feed the 12v supply right to the same place as the batter would. Great wow factor. Thanks for helping me talk it through Scotty!!

Back to your design work!


Phil, Tyler TX- from my iPad3.5 using Tapatalk HD

:thumbup: You didn't need me, I was just a sounding board. Glad you found the answer.