canamspyderaccessories F3 hitch adapter

[Trbayth]

I'm going to add Pierre's F3/F3S hitch to my F3. His harness comes with a 4 pin flat plug but we have an RT-622 trailer. I haven't been able to find an adapter that will go from 4-pin flat to 4-pin square. Lamont's adapter is the other way around (OEM harness to non-BRP trailer.) Anyone have a lead on the correct adapter?

 

[3Tyme]

https://www.amazon.com/807-Connector-Tailgate-Extension-Square-Plug/dp/B07RM6WVNN?th=1

 

[IdahoMtnSpyder]

Cut the flat four in two and tape (or heat shrink tube) one half on top of the other. It'll then fit the square four. I haven't done this myself but others here on the forum have.

 

[Haze]

Hey Roger,
I did the cut and tape of the Flat 4 to make a
Square 4 for the hitch on my previous ST.
It worked without a problem.
Good Luck, David C.

 

[Copperman]

Check with Lamonster Garage. They sell an adaptor that works.

http://www.lamonstergarage.com/can-am-spyder-trailer-harness-adapter-lamonster/

 

[Trbayth]

Hey Roger,
I did the cut and tape of the Flat 4 to make a
Square 4 for the hitch on my previous ST.
It worked without a problem.
Good Luck, David C.

Thanks Dave. It never dawned on me to cut the Flat 4. I needed something quick so in the end I bought a trailer kit at Harbor Freight, cut off one of the flat 4's and spliced it into the trailer's wiring. Now that we're back from our trip I have the time to do it "right".

 

[Jdr00ejr]

Our best friend has the 4 square on her Spyder and Trailer - and I have the Flat 4 on my Spyder and Vision. I bought a square 4 and flat 4 extension and cut them up to make my own adapter (both ways) - so I can tow her trailer with my stuff - and she can tow my flat 4 with her Spyder if necessary. The wiring of the adapter is sure straight forward.