Belt Guard

[GMAN9]

Well...rode my Spyder to church on Sunday...like a good little boy. Started to pull out of my parking space to leave...heard a nice little crunching sound. Me and a few gatherers who heard the same sound....spent a few minutes trying to figure out where it was coming from. Looked everywhere and finally discovered the belt guard had been sucked up towards the front part of the front belt sprocket. I guess it had come off when I was backing up in the parking space. Lucky for me it wasn't while I was going 70 down the interstate. A small piece was broken off of the tip, other than that, it is fine. So the question is, what size bolts and nuts hold that thing on. I don't have a service manual, so I thought someone would could look that up for me. And yes, i will put lots of lock-tight on those suckers!

Thanks again...love this site!

 

[BLUEKNIGHT911]

You can look here

Procaliber.com...............has Parts on a Fiche' that you look at on-line .....it will also tell what every size (and location) of all the nuts and bolts are ....plus if you register ( it's free) the parts are discounted................good luck...........Mike :thumbup:

 

[DrewNJ]

Can you snap a quick pic of which guard your talking about?
Most of that hardware is m6. Likely m6x25mm

 

[Bfromla]

here's a pic of mine off STL same issue dealer suppose to replace with longer bolts tomorrow when I get rear tire done fyi


Sent from my iPad using Tapatalk

 

[djhobin]

Belt Guard for the ST

I have a 2013 ST and there was a service bulletin about the bolts coming loose from the belt guard. I not sure the exact date, however I think it was in Jan of 2014 and was done at my first 600 mile service. My dealer fixed it for me under warranty.:clap: Good Idea to check it every now and then especially easy to do. :f_spider:

Dennis

 

[Bfromla]

See you @spyderfest!


Sent from my iPad using Tapatalk

 

[Chupaca]

Little checking..!!

you can also go to cheapcycleparts.com and check parts lists and order at discounted prices...:thumbup:they are M6x12