Anyone know how to remedy Hyperflash?

[Lew L]

I didn't

I have also had to resort to resistors, although i was hoping today was the day to install, didn't happen. Can I ask where you mounted them so they were attached to metal??

Thanks
Ray

I attached a piece of 16 ga. aluminum to the resistor ( about 1" x 2.5" ) It's just a heat sink. Its been a year since I did this and NO problems.

Kaos

 

[bcer960]

Thanks Kaos, good idea....

 

[Matahead]

Resistors F & R

I have also had to resort to resistors, although i was hoping today was the day to install, didn't happen. Can I ask where you mounted them so they were attached to metal??

Thanks
Ray

Front Resistors on the GS were behind the instrument cluster, on top of the frame end piece. Ground was to the frame, behind the bars, under the lobster Tupperware. Rear were on L brackets I put behind the battery. These brackets held the run-turn-brake module, & resistors. I used one group resistor front, one back, much easier than one each corner.

 

[bcer960]

Front Resistors on the GS were behind the instrument cluster, on top of the frame end piece. Ground was to the frame, behind the bars, under the lobster Tupperware. Rear were on L brackets I put behind the battery. These brackets held the run-turn-brake module, & resistors. I used one group resistor front, one back, much easier than one each corner.

I only got 2 resistors, one for each direction... you put 4 on? what was the value?? mine are 6.8K at 50W

Ray

 

[Matahead]

Zero value. . .

I only got 2 resistors, one for each direction... you put 4 on? what was the value?? mine are 6.8K at 50W

Ray

I had one front, one rear. 4.5k didn't work, completely. They slowed, but not normal.