Any room under the pass. seat on a 2022 Spyder RT Sea to Sky?

[HastingsRider]

Wondering if anyone has found a place to mount a fuse block under the passengers seat. My ride is currently in storage so i can't check myself yet. The box is about 1.5inches high, 2inches wide and 3inches long. Its a little smaller than the ShowChrome fuse block.

Thanks in advance for any assistance that you can provide.

 

[Mike0123]

Well, I have a 2021 RTL and I'd have to say no. I haven't tried it, but I doubt it.

 

[Peteoz]

I was looking to put a prop for my seat underneath the seat, Hastings, and found there was little space. BUT…..you won’t know until you try unless someone chimes in that they have already done it. Cut yourself a block of wood in the size of the box and try popping it in some likely looking places under the seat to see if there is any contact.

Pete

 

[spyderdave]

Unless something has changed from '20 to '22 models there is little, if any, room under the rear seat.

I would suggest, that when you get your S2S out of storage, you search under either side access panel for a location; or remove the "fang panel" and perhaps locate something there.

Personally, I located a fused junction block under the center console and used inline fuses for individual circuits (they take up less room elsewhere).

 

[HastingsRider]

Thanks all for the input. I didn't remember seeing much room. I appreciate the quick responses.

 

[al0vely]

No room under the seat … I just mounted the show chrome box under the top LH panel .

 

[Knizar]

No room under the seat … I just mounted the show chrome box under the top LH panel .

Ditto! Same Here, easy access on the 2020+ RT.

 

[HastingsRider]

Thanks for the replies. For those that have mounted the showchrome harness as pictured is it attached to something or just dependent upon wires to keep in place ?

 

[al0vely]

Thanks for the replies. For those that have mounted the showchrome harness as pictured is it attached to something or just dependent upon wires to keep in place ?

The SC box was mounted with Velcro and the Wesbar trailer connector came with sticky tape on the back.

 

[HastingsRider]

Thank you !