Another seat question,

[MOSESS]

I have finally installed my new seat and I only have one question, On my stock RT -S seat there is a harness for the heat and the passenger detection sensor. I just built my solo seat and in doing so I had to cut up the pan where the sensor mounted, I had to fiberglass the pan to add some strength back to the pan, do I need to reconnect the harness . I don't need the heat in the summer nor will it ever have a passenger . You tech guys what you think.....

 

[Bob Denman]

Can you simply plug the sensor in to the harness, and tuck it in somewhere underneath your seat?
(I think that if you just leave it unplugged: you'll get some error messages...)

:nopic:

 

[MOSESS]

Hi Bob

Hi there, I have two seats. I just installed the solo seat and left the other intact . There is no room to attach the part that mounts on the seat. I had to fiberglass the bottom of the pan flat to make it fit. the solo seat sits 5inchs further back. some one may know more. thanks..

 

[Bob Denman]

Just leave the sensor loose, and tuck it in underneath the seat... :thumbup:

 

[MOSESS]

Presently

That's the plan was looking for any info saying I should not do it. thanks.

 

[Bob Denman]

Try leaving it unplugged: I believe that your bike will throw codes...
(Plugging it back in will allow them to clear, so no harm is done! :thumbup