2017 F3 Limited handgrips - what size replacements?

[NCDragon]

Greetings All,

I would like to replace the original hand-grips with Kuryakyn ISO grips but, I'm not sure if I have 7/8 inch or 1" handlebars. I looked in the manual and musta missed the info cause I t'ain't seeing it!

At $75 a shot I want to make sure I order the correct grips the first time. Thanks! :spyder2:

 

[ofdave]

The bars are 1 1/8" on my F3 base model.
They may taper to a smaller diameter at the grip ends. Never had the grips off to check.

 

[Peteoz]

The handlebars on a Spyder are different because the bars themselves end at the grips....I.e. the grips are a separate component. This has been discussed before, but I can’t remember the outcome. I do believe ISO grips for a Goldwing fit..... If you do a search for replacement grips and Gold Wing you should find some references.

Pete

 

[Peteoz]

Here’s Lamont showing an ISO install.....there might be something in there....
http://www.spyderlovers.com/forums/...-on-the-RT-(with-heat)&highlight=Grip+install

Pete

 

[NCDragon]

Handgrip replacement

Thanks for the input Gentlemen! I'll do some research here on the board as well.

 

[SpyderPolly]

KURYAKYN ISO GRIPS 7/8 OR 1 INCH

Want to up grade to a larger diameter grips for obvious comfort reasons. On my 17' F3L should I purchase a 1 inch or 7/8 inch set because it will go over the stock heated grips.. I am of belief the 7/8 will be too small as I will not remove but just trim the end of the stock grips so I can slide over the larger Kuryakyn set.