Where is the best place to mount the AutoTune O2 Sensor??

[Questions]

Does anyone know where the best place is to mount the O2 sensor for the AutoTune system by DynoJet???
Need Help!
Thanks,
Peter

 

[D-Nice]

I put mine on the opposite side of the stock O2 sensor at about the same angle. Autotune suggest that you mount it at I think a 45Degree angle so that's how I mounted it. The stock pipes are stainless and it's a :cus: it drill out I burned up two bits and then from the heat build up the metal got hardened and became a even bigger pain so I ended up using a oxy touch to cut the remaining metal out then welded in the bung. Hope this helps good luck.

 

[Questions]

I put mine on the opposite side of the stock O2 sensor at about the same angle. Autotune suggest that you mount it at I think a 45Degree angle so that's how I mounted it. The stock pipes are stainless and it's a :cus: it drill out I burned up two bits and then from the heat build up the metal got hardened and became a even bigger pain so I ended up using a oxy touch to cut the remaining metal out then welded in the bung. Hope this helps good luck.

Thank you! Did you get a good tune from placing it there? Did everything work out properly?
Thanks

 

[2333]

On 2333, I have the sensor in the factory location, and the Evoluzione modifier plugged into the factory harness. No cutting or welding required.

 

[D-Nice]

Yes so far so good, bike runs smoother than ever with noticeable power and torque gain. I'm also running kewlmetal intake and Two Bros Duel Carbon Fiber Exhaust.

 

[WrapFactory]

Everyone asks me what kind of difference the PCV makes, the only word I can use to sum it up is "smoother".