• There were many reasons for the change of the site software, the biggest was security. The age of the old software also meant no server updates for certain programs. There are many benefits to the new software, one of the biggest is the mobile functionality. Ill fix up some stuff in the coming days, we'll also try to get some of the old addons back or the data imported back into the site like the garage. To create a thread or to reply with a post is basically the same as it was in the prior software. The default style of the site is light colored, but i temporarily added a darker colored style, to change you can find a link at the bottom of the site.

Wheelchair Rack

Looks great. I did notice in one picture of the rear support bracket. You welded to the end of the axle. That is OK the part I'm worried about. There is no support gusset from the horizontal axle bar to the vertical tube. That is the #1 load carrying point. There is one just below going out to the chair frame.
I'm not an engineer. But I have been welding for over 40yrs. A 1-1/2" gusset welded there. If for anything else. Piece of mine. I would check with the designer before you send it to be power coated.
 
wheelchair Carrier

Hi Roho

This is my W/C carrier and I have it much closer to the Spyder and attached to a Givi frame. It is hooked onto the push rims and bracket on the front as you will see in the movie. [video=facebook;124377321012262]http://www.facebook.com/video/video.php?v=124377321012262[/video]
If you have time lookm up 3wheels.org and you will see a few more trikes





I've finally gotten my wheelchair rack constructed! It hasn't been powder coated yet, so it looks a little rough, but it works fantastic and leaves room for a passenger. :ohyea::ohyea::ohyea:
Roho

http://www.spyderlovers.com/forums/album.php?albumid=447
 
Back
Top