What Phone/GPS Holder works with the early RT Handlebars?

[Islander2017]

I have a 2013 Spyder RT and I'm looking for a Phone/GPS bracket/holder that will fit on the unusually shaped handle bars on this model.

 

[racoon]

Tackform.com makes several mounts that replace one of the handlebar bolts.
I'd contact them to confirm which version works with your Spyder.

 

[jchadwi]

I have the Lamonster Spyder Cuff on the left handle bar to hold my iPhone. The GPS in mounted in the center of the bars on a ball mount.

Lamonster® RT Spyder Cuff™ with Lamonster® Phone Phang Holder

#1 Source for Aftermarket Can-Am Spyder and Ryker Parts and Accessories!! by Lamonster

www.lamonstergarage.com

 

[Islander2017]

Tackform.com makes several mounts that replace one of the handlebar bolts.
I'd contact them to confirm which version works with your Spyder.

Thank you!

 

[Islander2017]

I have the Lamonster Spyder Cuff on the left handle bar to hold my iPhone. The GPS in mounted in the center of the bars on a ball mount.

Lamonster® RT Spyder Cuff™ with Lamonster® Phone Phang Holder

#1 Source for Aftermarket Can-Am Spyder and Ryker Parts and Accessories!! by Lamonster

www.lamonstergarage.com

Thank you, very helpful.

 

[safecracker]

Check out Spyder To Go. On Amazon

 

[LongIsland]

canamspyderaccessories.com sells a bolt with a ram mount that replaces one of the 4 screws in the middle of the handlebar.

​

 

[jbs1218]

I have the Lamonster Spyder Cuff on the left handle bar to hold my iPhone. The GPS in mounted in the center of the bars on a ball mount.

Lamonster® RT Spyder Cuff™ with Lamonster® Phone Phang Holder

#1 Source for Aftermarket Can-Am Spyder and Ryker Parts and Accessories!! by Lamonster

www.lamonstergarage.com

I have used the same setup on my 2016 RT for the last 41,000 miles and it has performed flawlessly. My Garmin XT is also mounted in the middle of the handlebar when I am touring. The only potential issue you might have is accidentally knocking the phone off with your left hand if you are not paying attention since the clamp is spring loaded.

 

[pegasus1300]

I used 2 hose clamps to hold a straight ram mount to the handlebar. Works great. I'll take a picture and post it. Oh... it was also very cheap!

 

[Lew L]

I made a dash mount out of scrap aluminum. It's a copy of the one the JT used to sell here. 4 holes to mount whatever. I have the GPS and a clock with a ram ball for whatever I need. The LM660 Garmin is high, and I don't lose vision of the view ahead. A few straight ram bars for positioning. I also have a cuff to hold my drink.

And there you are...

Spyder RT 10-19, RAM 1" Ball Compatible Dash Mount (Black Powder Coated)

Spyder RT Dash Mount, RAM 1" Ball Compatible

store.valueaccessories.net

Lew L