Thunder QQ Baffle

[Hypurone]

Anyone have one of these that can send me some measurements? In particular, the OD of the sleeve portion and its length plus the overall length of the entire baffle?

Been calling Lamonster but no answer or call back from Jakob....

 

[BLUEKNIGHT911]

Big T Baffle

Anyone have one of these that can send me some measurements? In particular, the OD of the sleeve portion and its length plus the overall length of the entire baffle?

Been calling Lamonster but no answer or call back from Jakob....

The OD is the same as the ID of the muffler pipes..... I made mine and the tapered part was about 2.5 inches long , this is where I drilled the holes .....works fine ..... Mike :thumbup:

 

[Hypurone]

The OD is the same as the ID of the muffler pipes..... I made mine and the tapered part was about 2.5 inches long , this is where I drilled the holes .....works fine ..... Mike :thumbup:

Not sure this helps me as I have the Akrapovic Straight Shot which I believe has a larger inlet diameter than the stock piece and I'm using a different mid-pipe (not Lamonster) and I don't have a micrometer that can reach in far enough to measure its diameter

 

[Hypurone]

Finally!

Got the info needed. Whew.....

 

[T.P.]

I have a 2017 F-3 from Pitbull Powersports with their 1330 Primary Muffler Replacement Pipe.

I also have the Thunder QQ baffle from Lamonster garage.

The OD of the baffle is way smaller then the ID of this pipe.

T.P.

 

[fencepost]

You can call Big City Thunder and get a sleeve if you are concerend about the gap. I have installed the baffle both ways and the only difference was the time and work it took to fit the sleeve.

 

[Hypurone]

You can call Big City Thunder and get a sleeve if you are concerend about the gap. I have installed the baffle both ways and the only difference was the time and work it took to fit the sleeve.

as stated in post #4, I got the info needed.

I'm done with my project! :yes: