• There were many reasons for the change of the site software, the biggest was security. The age of the old software also meant no server updates for certain programs. There are many benefits to the new software, one of the biggest is the mobile functionality. Ill fix up some stuff in the coming days, we'll also try to get some of the old addons back or the data imported back into the site like the garage. To create a thread or to reply with a post is basically the same as it was in the prior software. The default style of the site is light colored, but i temporarily added a darker colored style, to change you can find a link at the bottom of the site.

This is probably the dumbest question ever asked for 2013 Spyder RT SE

P

poordom

New member
Good afternoon All,
This is probably the dumbest question ever asked

​

Let me explain, I decided to trade in my 2009 Spyder RS, for a 2013 Spyder RT SE.

The Spyder was purchased at a used car dealership, because of temperature and snow conditions, the trike was delivered this morning on a flatbed,

Once of the flatbed, I tried starting it, using the procedures I am used too, well that didn't work, actually nothing worked, the gauge panel and electronic display are completely blank, nothing, nada, zippo.

I went through the manual, and can't find specific starting procedures, the garage from whom I purchased the trike have no clue, what else.

I have place the battery on a charger, thinking that would be the problem, nothing.

Where can I find " Starting Procedures " for my 2013 Spyder RT SE.

Thanks guys for your assistance.

Dom:shocked::shocked::shocked:








 
It could very well be a bad battery, as in dead. That would be the first place to look.

There may also be a reason why the :spyder2: ended up at a used car dealer, but I wont go there at this time. Let's hope you find an easy fix. Fingers crossed. :yes::yes:
 
Open the front trunk and on the rear wall is the access door for the battery. Check the battery connections. Sounds like a bad connection or dead battery. Some dealers will disconnect the neg battery cable when vehicles are indoors on the showroom.

The display should light up just turning on the key. Then once the ECM boots up it will direct you to push the MODE button and the normal display will come up and its ready to start. Make sure the run switch is in the run position (red switch near your right thumb) and your foot on the brake, then press the start button.
 
jcthorne said:
Open the front trunk and on the rear wall is the access door for the battery. Check the battery connections. Sounds like a bad connection or dead battery. Some dealers will disconnect the neg battery cable when vehicles are indoors on the showroom.

The display should light up just turning on the key. Then once the ECM boots up it will direct you to push the MODE button and the normal display will come up and its ready to start. Make sure the run switch is in the run position (red switch near your right thumb) and your foot on the brake, then press the start button.
Click to expand...

I did all the rest, except for my foot on the brake. Which I will try later.
 
Once you do get it running, get to a dealer and have them verify whether the past recalls on it were done . . . pretty important ones have occurred . . .
 
This is probably the dumbest question ever asked for 2013 Spyder RT SE ( REVISED )

jcthorne said:
Did you check that the battery was charged? Foot on the brake won't matter if the ECM is not booting up and the display is bwcnot starting.....
Click to expand...


Well, the battery is dead as a door knob, I connected my portable power pack to the battery, and everything lite.

But it wouldn't start, then I noticed that the letter R in the left gauge stays on, which I have to assume is for reverse.

I can only guess that if the trike is in Reverse, it won`t start. So the question now is: how do I get it out of reverse.

Dom
 
poordom said:
Well, the battery is dead as a door knob, I connected my portable power pack to the battery, and everything lite.

But it wouldn't start, then I noticed that the letter R in the left gauge stays on, which I have to assume is for reverse.

I can only guess that if the trike is in Reverse, it won`t start. So the question now is: how do I get it out of reverse.

Dom
Click to expand...

Start with your foot on the brake and after it starts it will shift to neutral on it's own.
 
[QUOTE
Where can I find " Starting Procedures " for my 2013 Spyder RT SE.

[/QUOTE]

If you look above the instrument cluster there's a pullout card that will walk you through everything you need to know.
 
You must log in or register to reply here.

Similar threads

J
2022 Spyder RT-L S2S - which side of the bike is the Front Running Light wiring harness likely to be?
Replies
1
Views
172
Snowbelt Spyder
Snowbelt Spyder
bt2mack
Don't cut the cable to mount a Zumo 595 LM! See this site instead!
Replies
0
Views
220
bt2mack
bt2mack
O
My First Spyder - F3S. But the brakes need a really hard push, is this normal?
Replies
11
Views
598
66Roseracing66
66Roseracing66
A
Is there a supplier selling Saddle bag liners for only the 2 bags on a '23 Spyder RT Limited?
Replies
4
Views
249
troop
troop
M
Anyone got a valid reason for the High Torque settings on the brake rotor?
Replies
7
Views
6K
mgardiner2673
M
Back
Top