Switched power

[Arr MiHardies]

Can anyone help me figure out where I can tap into switched power easily? I just installed a switched fuze block I got from Reggy. It's all set I just need to tap a switched line. I mounted my block under the empty black panel on the left front of the bike under the hood. Looking for something as close as possible to this as I can get. I've taken off the sided panels but not the front Tupperware, which I'm not terribly inclined to do. I can see where the fender running lights come up to directly under where my block is, but I can't get to the wire to tap into it without apparently removing the frunk. Advice here is appreciated.

 

[SPYD1]

RS or RT?

 

[Arr MiHardies]

This is the shop talk forum, thought rt would have been assumed. Still, it's an RT. any help is very appreciated.

 

[SPYD1]

Sooo sorry I saw it on the "what's new" area? Can't help you with RT but someone will...

 

[Arr MiHardies]

No worries. Was trying not to come off as insulting in that last post. Sorry if it came out like that.

 

[SPYD1]

Not at all...all is well.

 

[NancysToy]

Easiest to get to in the rear is the light on the heated passenger grip switch. Up front the easiest to access are the analog gauge lights if you have them. You may have to fish the wire to your box, but you only need to remove four bolts to remove the dash to access the gauge lighting wires.

 

[Arr MiHardies]

Yeah. I just did that a moment ago. Had the bike entirely reassembled sans one screw, when the bit on my screwdriver fell out and down into the hole for the handlebars. GAH!!!!!! Had to take the bike half apart again just to get it out.

On the upside. The only thing I have left to do is install my adaptive driving lights, but I'm outta gas. Time to take a break. I'll post pics with all my new farkles in a bit. Really liking how they are turning out.