-
There were many reasons for the change of the site software, the biggest was security. The age of the old software also meant no server updates for certain programs. There are many benefits to the new software, one of the biggest is the mobile functionality. Ill fix up some stuff in the coming days, we'll also try to get some of the old addons back or the data imported back into the site like the garage. To create a thread or to reply with a post is basically the same as it was in the prior software. The default style of the site is light colored, but i temporarily added a darker colored style, to change you can find a link at the bottom of the site.
Sway bars
- Thread starter Cindi
- Start date
Farmbanker
New member
:agree: Easy peasy! Great results.
SpyderAnn01
Active member
Install is pretty easy do you have a motorcycle jack and jack stands?
Bob Denman
New member
:shocked: Even I managed to install it with no loss of blood... :2thumbs: 
hyea::yes: And I've got the mechanical aptitude of a hamster!
hyea::yes: And I've got the mechanical aptitude of a hamster!
FaranH
GOS Founding Member (Girls On Spyders)
Cindi,
My dad and I installed mine last week and I'd say it's not too bad. We did not remove the frunk, just removed the two lower bolts and the two at the back of the fog light panel so that you had plenty of "play" to move the frunk out 2" or so. It was helpful to have another set of hands (mine were the "extra" hands
), but now that I've done it, I think I could do it again on my own if I had a better jacking/lift system.
Read the instructions thoroughly and good luck!
My dad and I installed mine last week and I'd say it's not too bad. We did not remove the frunk, just removed the two lower bolts and the two at the back of the fog light panel so that you had plenty of "play" to move the frunk out 2" or so. It was helpful to have another set of hands (mine were the "extra" hands
), but now that I've done it, I think I could do it again on my own if I had a better jacking/lift system.Read the instructions thoroughly and good luck!
BajaRon
Well-known member
You can PM me here on Spyderlovers or email me at [email protected] to purchase a Sway Bar kit. Either way works fine. I think the install is more mentally intimidating than it is actually difficult. Most complete the install in about 1-1/2 hours. And everyone says they could do it in 1/2 that time if they did it again.
It is not necessary to remove the Frunk for this install.
:shocked: Even I managed to install it with no loss of blood... :2thumbs:
A very resourceful Hampster!
I have the SpyderPops bumbskid installed. Do I have to remove it to install?
pikelakejohn
New member
Yes.
Yelhelp
New member
anti sway bar
I to have a skid plate and installed it two weeks before I put the anti sway bar on and yes i HAD TO TAKE THE SKID PLATE OFF . But now I could do them both again cause i have lots of practise.
:yes:
I to have a skid plate and installed it two weeks before I put the anti sway bar on and yes i HAD TO TAKE THE SKID PLATE OFF . But now I could do them both again cause i have lots of practise.
:yes:
Similar threads
