• There were many reasons for the change of the site software, the biggest was security. The age of the old software also meant no server updates for certain programs. There are many benefits to the new software, one of the biggest is the mobile functionality. Ill fix up some stuff in the coming days, we'll also try to get some of the old addons back or the data imported back into the site like the garage. To create a thread or to reply with a post is basically the same as it was in the prior software. The default style of the site is light colored, but i temporarily added a darker colored style, to change you can find a link at the bottom of the site.

RT wiring to flat four quick fix?

In general, piggybacked converters do not work. The Spyder already has a trailer module built into its connector, so to use the converter, you would have to tap in prior to the trailer module. Not sure why you would want one, anywway. The Spyder RT trailer modules after 2010 already have 4-wire output. You just need the connectors to match. The connector you have shown is the wrong side...same as the one on the Spyder. You need the one with the locking ring. You will also need the sockets (pins), the blank hole plugs, a rear boot, and the special crimping pliers. Doubt you'll get out of it for $30. That is why most folks just purchase the 2010 trailer tongue harness or the 2011/2012 trailer pole harness to wire to their trailer or make into an adapter.
 
You must log in or register to reply here.
Back
Top