RS-S Dual Exhaust Custom Mod

[T-Dawg]

OK.
I love my RS-S, but I can't stand the lop-sided view from the back. I am dying to put dual exhaust on BOTH sides.
There was a Spyder at bike week that had this done and it was awesome. They used STARKS 94 mufflers from Two-Brothers, but they seemed to be custom made, as the labels showed on both side as if made for left and right.
SO.....Has anyone else done this? If so, can you feed me the information. I'm not concerned about the cutting and welding. I just need to gather the materials to accomplish this before Maggie Valley.
T-Dawg

 

[Y Rider]

OK.
I love my RS-S, but I can't stand the lop-sided view from the back. I am dying to put dual exhaust on BOTH sides.
There was a Spyder at bike week that had this done and it was awesome. They used STARKS 94 mufflers from Two-Brothers, but they seemed to be custom made, as the labels showed on both side as if made for left and right.
SO.....Has anyone else done this? If so, can you feed me the information. I'm not concerned about the cutting and welding. I just need to gather the materials to accomplish this before Maggie Valley.
T-Dawg

Check out this thread: http://www.spyderlovers.com/forums/showthread.php?t=27553

 

[ataDude]

Or here: http://www.spyderlovers.com/forums/showpost.php?p=78971&postcount=116 .

 

[reggystan]

The Green Bike you saw at Bike week belongs to Randy Starks #94 of the Miami dolphins. It is a dual CF TwoBros pipe with a custom mid section that was fabricated. The label can be ordered that way in the custom shop from TB. It just takes some time and lining up to get it to line up precisely.

OK.
I love my RS-S, but I can't stand the lop-sided view from the back. I am dying to put dual exhaust on BOTH sides.
There was a Spyder at bike week that had this done and it was awesome. They used STARKS 94 mufflers from Two-Brothers, but they seemed to be custom made, as the labels showed on both side as if made for left and right.
SO.....Has anyone else done this? If so, can you feed me the information. I'm not concerned about the cutting and welding. I just need to gather the materials to accomplish this before Maggie Valley.
T-Dawg