RS headlamp replacement

[McGone]

I am trying to change a burnt out headlamp on my 2008 SM5. The service manual says to turn the connector counterclockwise to remove it from the housing. How do you do this? Is there a special trick to this?

Thanks

 

[nudle]

I replaced both headlight bulbs on my RS. I Have big hand and had to remove the top half off the clam which was not too hard. It made changing the bulbs alot easier.

 

[groundeffect]

I am trying to change a burnt out headlamp on my 2008 SM5. The service manual says to turn the connector counterclockwise to remove it from the housing. How do you do this? Is there a special trick to this?

Thanks

Hey there. Yep, you have to get behind the cluster really good - take the cluster off to have some extra room, as you will need it. I also recommend wearing a pair of thin gloves. These will help you grip the bulb housing better to get that counterclockwise turn and protect your hand from rubbing on the edge of the console.

From my experience the headlights typically go about the same time. If you are replacing one, best replace the other while you're there. Also note that you'll have to reset the time on the cluster once you reconnect.

You'll get it!
Hope that helps.
Cheers from Newfoundland!