Guys I installed the front bumper today. Install instructions are very good, You can do this by yourself, Start by removing the frump lining , I then drove the rt up onto a car ramps, make sure to put the e brake on. In the kit you will see a bracket that has two square holes in it and 2 smaller though holes to the out side. I know I should have taken pics, lay the bracket in the frunk over the square molding that sticks up. I used a 5/16th drill bit. in the instructions it says to remove the bottom center cover, I left that on so I can spot the Delete repeated word holes with the 5/16th drill. Once you drill the holes. Remove the center cover, take a 3/4 hole saw and open those holes. one more thing to do to the cover, Notch the cover 1/2 in wide by 1-1/4. at this time remove the other two covers. you will see this in the instructions. tools you will need, 1/4inch drive socket wrench with a 10mm socket and one small Allen wrench say 1/8th . sense most of us are alone when we will do this job I had to improvise a little now the fun begins, Install the center cover, now is the time you will install the bumper. in the hardware packet take the two 6mm bolts along with lock washer and flat washer and set them to the side under the Rt where you can reach them. lift the bumper up and install the Allen wrench on one side and try as you may to install one bolt. got it good now lift the front of the bumper and install one of the shoulder bolts from the bottom up install nylock nut and washer. then do the next one, got it good, then head back underneath and install the 6mm bolt where you had the Allen wrench . You can now tighten those two bolts. you can now install the other two covers while your down there.. once up tighten the two 10mm nuts in the frunk and then install the frunk lining. job is done clean up finger prints and tools .This is my first post of this kind. Thanks guys what you think 
