New DIY Floorboards, Cheap TPMS, Daylight visible turn indicators +more (Many Pix)

[Eviltwin]

Better view of the underside:


Rear mount with the rubber sleeve:


Plate for bottom of rear mount:


Better view of the rubber mounts for the rear:


Cutting the rubber block on the bandsaw

 

[Tonylmiller]

Thanks, looks like you just ran the bolt through the slot for the rear passenger floorboards. Good to know.
I just had an idea. If you could trace your templates, or the finished products, and take a flat picture with a ruler on the long dimensions, I could just print it and scale it correctly. Probably easier than mailing it.

 

[BLUEKNIGHT911]

:clap::clap::clap: .... I DIY'ed the floorboards on 1`4 RT .... similar to yours ..... Make sure the BRAKE Pedal is able to achieve MAX pressure when depressed. The OEM system allows the floor board to actually move downwards a bit in an absolute Panic stop. Very nice work ..... Mike :thumbup:

 

[Eviltwin]

This is the side with the brake pedal:



I'll see what I can do about measuring the actual floor boards. At the time I wanted to get 1/4" diamond tread, but ended up with 1/8" which turns out was fine in terms of strength. Since the boards are supported on either end, there is no flex to worry about.

 

[Eviltwin]

This is the rubber block I bought off Amazon for the rear mounts:



Carriage bolts are stainless, something like this should work:



I'll try and get the measurements a bit later.