MY SATURDAY RIDE

[vernal brown]

WE HAVE A 20156 RTS SE6 SPIDER ABOUT 13 MONTHS OLD WITH 7500 MILES ON IT.
YESTERDAY THE WIFE AND I WENT FOR A RIDE, WE ENTERED A WORK ZONE (15MPH) AND ALL OF A SUDDEN THE LEFT MIRROR FELL OFF , ONLY TO BE HELD BY THE ELECTRICAL CORD. WE IMMEDIATELY PULLED OVER AND TRIED TO INTALL IT BACK ON THE BIKE, IT HAS TO BE SLIDE IN THREE DIFFERENT DIRECTIONS. SO DECIDED TO WAIT AND HAVE THE DEALER RE-INSTALL IT (THERE HAS TO BE A TRICK TO INSTALLING IT. MY TWO QUESTIONS 1) WAS IT INSTALLED CORRECT IN THE FIRST PLACE. 2) WILL IT BE COVERED BY THE WARRENTY THERE FOR WE ARE DISAPOINTED IN THE QUALITY OF THE SPIDER

 

[Highwayman2013]

It probably wasn't installed correctly, top connector hooks on, bottom two are spring loaded. Has nothing to do with the quality of the spyder.

 

[vernal brown]

WE HAVE A 20156 RTS SE6 SPIDER ABOUT 13 MONTHS OLD WITH 7500 MILES ON IT.
YESTERDAY THE WIFE AND I WENT FOR A RIDE, WE ENTERED A WORK ZONE (15MPH) AND ALL OF A SUDDEN THE LEFT MIRROR FELL OFF , ONLY TO BE HELD BY THE ELECTRICAL CORD. WE IMMEDIATELY PULLED OVER AND TRIED TO INTALL IT BACK ON THE BIKE, IT HAS TO BE SLIDE IN THREE DIFFERENT DIRECTIONS. SO DECIDED TO WAIT AND HAVE THE DEALER RE-INSTALL IT (THERE HAS TO BE A TRICK TO INSTALLING IT. MY TWO QUESTIONS 1) WAS IT INSTALLED CORRECT IN THE FIRST PLACE. 2) WILL IT BE COVERED BY THE WARRENTY THERE FOR WE ARE DISAPOINTED IN THE QUALITY OF THE SPIDER

I figured out how to re-install the mirror. afterwards got back on this web site to see if anyone replied and there was the video on how to i thank the come-back and learned something today thanks

 

[Chupaca]

As I see it...

Because just about anything you do on the RT requires removing the mirror they came up with this system. May not be the best but it is wise to check them after any work has been done to your spyder. Lucky you were going slow and the wiring held on....:thumbup:

 

[vernal brown]

Because just about anything you do on the RT requires removing the mirror they came up with this system. May not be the best but it is wise to check them after any work has been done to your spyder. Lucky you were going slow and the wiring held on....:thumbup:

THANKS FOR GETTING BACK, I FIGURED IT OUT BUT I WAS NOT AWARE OF YOUR STATEMENT THANKS