Looking for a solid F3 mech - any recommendations - WV?

[chunkmonk]

Looking for a solid, dependable, knowledgeable mech to do some upgrades on my F3. Let me know if you know of anyone that you could recommend. Appreciate it.

 

[Navydad]

I don't know where you're located in West Virginia, but the guys at the Can Am dealership in Jackson, Ohio are good. They're also very busy this time of the year though.

 

[chunkmonk]

Well, Jackson, OH looks to be at least an hour or more North of Charleston. Charleston is 5 hours west of me (I'm close to Harpers Ferry/Eastern panhandle). So that's about a 7 hour ride... A bit far, but I appreciate the input.

 

[CopperSpyder]

MotorSportsInc In Hanover PA. Very Good Can Am Dealer, with very knowledgeable service department and prices better than ones a little closer to you. It is a bad time of year to get things done tho because the good ones are very busy this time of year. What upgrades do you want to do?

 

[chunkmonk]

Some of my list of farkles, mostly. I don't have a way of lifting the Spyder 24" so installing the anti-sway bar upgrade is out for me. I need to have my FIN installed and my GPS system wired in. I'd like to have the titanium/stainless stems installed on the wheels, and I'd like to balance them before re-mounting (then I can install the FoBo2). I'm not setting the auxiliary or gucci lighting in place until I get the Neutrino Aurora+ (that will be sometime in June). Also, since I have an extended warranty on the bike, I want to find a 'home dealer' that isn't either 3 hours away or doesn't just generally suck.

 

[IGETAROUND]

Some of my list of farkles, mostly. I don't have a way of lifting the Spyder 24" so installing the anti-sway bar upgrade is out for me. I need to have my FIN installed and my GPS system wired in. I'd like to have the titanium/stainless stems installed on the wheels, and I'd like to balance them before re-mounting (then I can install the FoBo2). I'm not setting the auxiliary or gucci lighting in place until I get the Neutrino Aurora+ (that will be sometime in June). Also, since I have an extended warranty on the bike, I want to find a 'home dealer' that isn't either 3 hours away or doesn't just generally suck.

If you go to any rallies that Captjam is at, he charges $75.00/hour and is the most competent wrench twister that I know.

Al in Kazoo

 

[CopperSpyder]

Some of my list of farkles, mostly. I don't have a way of lifting the Spyder 24" so installing the anti-sway bar upgrade is out for me. I need to have my FIN installed and my GPS system wired in. I'd like to have the titanium/stainless stems installed on the wheels, and I'd like to balance them before re-mounting (then I can install the FoBo2). I'm not setting the auxiliary or gucci lighting in place until I get the Neutrino Aurora+ (that will be sometime in June). Also, since I have an extended warranty on the bike, I want to find a 'home dealer' that isn't either 3 hours away or doesn't just generally suck.

The only dealer with a service department near you that I know of is Ridersville Cycle In BERKELEY SPRINGS, WV 25411; 75 GOOD TIMES DRIVE. the only thing I know about them is one person I know that has an F3 and takes his F3 there for service and he like them.