2019 F3-S Special Series, looking to install Rox Risers and need advise on best way to get additional cable slack. Love the fact that the spyder is so clean and concealed around the bars but not quite sure what parts I need to remove in order to manage the cable slack.
-
There were many reasons for the change of the site software, the biggest was security. The age of the old software also meant no server updates for certain programs. There are many benefits to the new software, one of the biggest is the mobile functionality. Ill fix up some stuff in the coming days, we'll also try to get some of the old addons back or the data imported back into the site like the garage. To create a thread or to reply with a post is basically the same as it was in the prior software. The default style of the site is light colored, but i temporarily added a darker colored style, to change you can find a link at the bottom of the site.
Installing Rox Risers
- Thread starter AzBTO
- Start date
BLUEKNIGHT911
Sadly Passed Oct 2024 - RIP
The F-3 has a few different sizes for their handlebars .... so there may very be enough slack to accomplish this ..... I put 4 inch risers on my GS and RSS and gept the OEM cables .... after cutting a few tie - wraps ..... good luck .... Mike :thumbup:
troop
Well-known member
Lamonster clips (2) zip ties for their billy club bars. I attempted generic risers on my f3s and didn't need to cut any ties. If you get the Rox risers, make sure you get these, as they have the extended stem .. https://roxspeedfx.com/collections/...ndlebar-with-extended-stem?variant=1187894173
Also, if you use an accessory powerport from Lamonster/Spyderextras, the risers won't work as you can't take advantage of the longer stems in the clamps. Just some fyi ...
http://www.lamonstergarage.com/billy-club-bar-install/
Also, if you use an accessory powerport from Lamonster/Spyderextras, the risers won't work as you can't take advantage of the longer stems in the clamps. Just some fyi ...
http://www.lamonstergarage.com/billy-club-bar-install/
I have a 2016 F3L with short reach bars and 2in Rox risers made for the F3. I removed the lower cable clamps on the bars then tugged the cable out from inside the trike and have had no problems at all in the 2 years its been installed.
Bob
Installed yesterday along with my shocks... not as much flexibility as I was hoping for. Given the lack of space between the new riser tops and the current bolts that hold the risers in place I ended up positioning the risers so i had easy access to tighten down the bolts which resulted in more higher vs back result. They held well but will need to give them a go before I have a final decision on them.
JP58
New member
If you want them closer to you. Loosen all clamp bolts. Then tighten just the 2 bottom bolts closest to you till they bottom out snug. Then rotate risers toward you. Will be a little stiff but will move. They will cover the lower bolts. No need to retighten lower bolts any futher. Then tighten the top bolts snug. You will be closer than and good to go.
Similar threads
