I'm looking for these Middle Side Panel Plastic Pins - 2014 RT. Any source/info?

[chris0749]

I'm looking for part number/source for pin/screw. These aren't shown in my service manual. They're for attaching item 365:

 

[Gwolf]

I got a selection of different push pins and screw down pins in a large box off the Internet. Got the right pins to fit most places on the Spyder, and a lot of the places on trucks that hold the interior panels, door panels, and stuff on. Cost a lot more than just buying one or two pins, but time is the same as money. If the pin is in the box I bought, and it saves me 2 hours hunting for a source on the web, or a trip to the big hardware store 15 miles away, then it is worth it.

 

[chipveres]

Harbor Freight SKU 57671 probably has them - no guarantees, check before spending money.

 

[Mikey]

Any auto store may have them, I know Napa, here in Maine have them. I got some from Lamonster here on site and few years ago! Or online, you need to know what size hole your trying to plug!

 

[NorwegianRT]

I could be wrong, but on my 2012 RTS, the panel 365 has three buildt in pins that is going into rubber o rings to hold it in place.
Sure looks like the same panel I just pull off to check oil level.

Or I can have miss understood the whole thing :dontknow:

 

[2dogs]

Panel #365 on my 14 RTS is not held on with pushpins. Mine are snapped into place using molded studs into a rubber grommet. The molded studs are a part of the panel. There is a small lip molded into the top of the panel that hooks around the larger side panel that you must be careful not to break.

 

[BLUEKNIGHT911]

Panel #365 on my 14 RTS is not held on with pushpins. Mine are snapped into place using molded studs into a rubber grommet. The molded studs are a part of the panel. There is a small lip molded into the top of the panel that hooks around the larger side panel that you must be careful not to break.

:agree: with posters #5 & #6 ..... what looks like a pin is for part # 187 ( chrome trim piece ) .... my 14 RT has molded studs on that panel ..... Mike :thumbup:

 

[chris0749]

Thanks for all the comments, but the picture I posted was wrong. The pins are for the Lateral Side Panels (Items 246 and 272 below). I didn't know that Item 246 was supposed to be angled.

Found the pins at www.can-amparts.com.

 

[NorwegianRT]

Glad you sorted that out :thumbup: